Samsung SV-265X SV-261I SV-651F free download

File name SV-265X_SV-261I_SV-651F.rar

IMPORTANT SERVICE GUIDE MODE SWITCH (PROGRAM SWITCH) ASSEMBLY POINT 1) When installing the ass'y deck on the Main PCB, be sure to align the assembly point of mode switch. ASSEMBLY POINT (ALIGN TWO ARROWS) Fig. 1 HOW TO EJECT THE CASSETTE TAPE (If the tape is stuck in the unit) 1) Turn the Gear Worm OE clockwise in the direction of arrow with a screwdriver. (See Fig. 2) (Other method ; Remove the screw of Motor Load Ass'y, Separate the Motor Load Ass'y) 2) When Slider S, T approach the unloading position, rotate holder Clutch counterclockwise after inserting screw driver in the frame's bottom hole in order to wind the unwound tape. (Refer to Fig. 3) (If you rotate Gear Worm OE continuously when tape is in state of unwinding, you may cause tape contamination by grease and tape damage. Be sure to wind the unwound tape in the state of set horizontally.) 3) Rotate Gear Worm OE clockwise using screw driver again up to the state of eject mode and then pick out the tape. (Refer to Fig. 2) OE GEAR WORM FRAME Fig. 2 Fig. 3 1. Precautions 1. Be sure that all of the built-in protective devices are replaced. Restore any missing protective shields. (READING SHOULD NOT BE ABOVE 0.5mA) LEAKAGE 2. When reinstalling the chassis and its assemblies, be DEVICE CURRENT UNDER TESTER sure to restore all protective devices, including : TEST control knobs and compartment covers. TEST ALL EXPOSED METER 3. Make sure that there are no cabinet openings SURFACES through which people--particularly children 2-WIRE CORD --might insert fingers and contact dangerous voltages. Such openings include the spacing ALSO TEST WITH EARTH